3 outputting part programs to a tape punch – Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 269
Communications
Chapter 9
9-13
If a program is in control memory and you want to send a copy of that
program to a peripheral device, follow these steps:
1.
Verify that the peripheral device is connected to the correct serial port
and that the port is configured for that device (see section 9.1.1).
2.
Press the {PRGRAM MANAGE} softkey. The control displays the
screen shown in Figure 9.4.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
Figure 9.4
Program Directory Screen
SELECTED PROGRAM:
DIRECTORY
PAGE
1
OF
1
NAME
SIZE
COMMENT
O12345
1.3
SUB TEST 1
TEST
3.9
NEW
MAIN
1.3
TTTE
1.3
THIS IS A TEST PROGRAM
4 FILES
127.5
METERS FREE
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
9.3
Outputting Part Programs to
a Tape Punch