Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 793)

Chapter 30
Using a 9/Series Dual--processing System
30-25
Figure 30.9
Backup Interference Boundary Screen
TO
PORT A
TO
PORT B
TO
FILE
STORE TO BACKUP
INTERFERENCE TABLE
5. Determine the destination for the G10 program:
To Send the G10 Program To: Press This Softkey: Go to Step:
peripheral attached to port A {TO PORT A} 7.
a peripheral attached to port B {TO PORT B} 7.
to control memory {TO FILE} 6.
6. Press the {TO FILE} softkey. The control asks for a program name.
By using the alphanumeric keys on the operator panel, enter the
program name you wish to call the backup program . Press the
[TRANSMIT] key once you have entered the program name. See
chapter 10 on program names. The G10 program is saved under the
file name just entered.
7. Press the {TO PORT A} or {TO PORT B} softkey. A {YES} or
{NO} softkey is displayed. Press {YES} to confirm or {NO} to
abort. If you confirm the operation, the G10 program is written to a
peripheral attached tot he selected port.