Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 85)

Offset Table and Setup
Chapter 3
3-11
Your system installer initially sets these values in AMP. You can modify
them with online AMP by using this screen:
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
MAXIMUM +/-- WEAR RADIUS
MAXIMUM +/-- GEOM RADIUS
MAXIMUM WEAR OFFSET CHANGE
MAXIMUM GEOM OFFSET CHANGE
MAXIMUM +/-- WEAR OFFSET
MAXIMUM +/-- GEOM OFFSET
NEXT
AXIS
OFFSET RANGE VERIFICATION
Per table values
Per axis values
[inch]
.12345
10.12345
[inch]
.01000
1.00000
.10000
10.00000
softkey level 5
About the Offset Range Verification Screen
display format is fixed
Mode Places to the left of the decimal point Places to the right of the decimal point
inch 3 5
metric 4 5
data entry is bounded by the programming resolution of the axes
When Does Verification Occur
Verification occurs when a value enters the table from:
• data entry screens • PAL • paramacros
Important: The control does not perform the verification if the value, old
or new, is zero, nor does it check G10 data-setting codes.