Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 732)

Paramacros
Chapter 28
28-32
#5671 to 5682
Acceleration Ramps for S- Curve Acc/Dec Mode
These parameters are read only. They correspond to the active acceleration
ramps in S--Curve Acc/Dec mode. You can set these parameters by
programming a G48.3 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5671 Axis 1 acceleration ramp 5677 Axis 7 acceleration ramp
5672 Axis 2 acceleration ramp 5678 Axis 8 acceleration ramp
5673 Axis 3 acceleration ramp 5679 Axis 9 acceleration ramp
5674 Axis 4 acceleration ramp 5680 Axis 10 acceleration ramp
5675 Axis 5 acceleration ramp 5681 Axis 11 acceleration ramp
5676 Axis 6 acceleration ramp 5682 Axis 12 acceleration ramp
#5691 to 5702
Deceleration Ramps for S- Curve Acc/Dec Mode
These parameters are read only. They correspond to the active deceleration
ramps in S--Curve Acc/Dec mode. You can set these parameters by
programming a G48.4 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5691 Axis 1 deceleration ramp 5697 Axis 7 deceleration ramp
5692 Axis 2 deceleration ramp 5698 Axis 8 deceleration ramp
5693 Axis 3 deceleration ramp 5699 Axis 9 deceleration ramp
5694 Axis 4 deceleration ramp 5700 Axis 10 deceleration ramp
5695 Axis 5 deceleration ramp 5701 Axis 11 deceleration ramp
5696 Axis 6 deceleration ramp 5702 Axis 12 deceleration ramp