Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 192)

Running a Program
Chapter 7
Running a Program
Chapter 7
7-10
Use the Program Search feature to begin program execution from some
block other than at the beginning of the program. This feature requires the
operator to establish the necessary G, M, S, F, and T words, work
coordinate offsets, etc., that should be active for that block’s execution.
The control is capable of starting a program at a chosen block and
establishing any previous G, M, S, F, and T words work coordinate offsets,
etc., that were established in previous blocks using the search with memory
feature. For details, see section 7.4.
The program search feature is not effective for subprograms and
paramacros; only blocks that are in the main program can be searched.
To perform a program search operation:
1. Press the {PRGRAM MANAGE} softkey. Note the program to
search must have previously been selected for automatic execution as
discussed in section 7.2.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {ACTIVE PRGRAM} softkey.
REFORM
MEMORY
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
7.5
Program Search {SEARCH}