Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 813)

Using Transfer Line Cycles
Chapter 31
31-11
6. After all data for the cycle has been entered store the data by pressing
the {STORE} softkey.
STORE
(softkey level 6)
The control will generate the cycle’s part program. See the section
titled Editing Part Programs to adjust your settings.
7. Press the {EXIT EDITOR} softkey to leave the editor and make the
program available for execution.
MODIFY
INSERT
(softkey level 3)
STRING
SEARCH
DIGITZ
E
BLOCK
DELETE
BLOCK
TRUNC
DELETE
CH/WRD
EXIT
EDITOR
RENUM
PRGRAM
MERGE
PRGRAM
QUICK
VIEW
CHAR/
WORD
8. Take the control out of E-stop or manual control mode
(through PAL). The control executes the program and monitors PAL
input for information on how to proceed.