Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 69)

Basic Control Operation
Chapter 2
2-45
You see the Time Parts screen:
Figure 2.10
Time Parts Screen
ED PRT
INFO
PROGRAM DATE TIME
XXXXXXXX MM/DD/YY HH:MM:SS
POWER-ON TIME/OVERALL : 99999:59:59
WORKPIECES CUT/OVERALL : 9999999999
RUN TIME : 99999:59:59
POWER-ON TIME/AFTER RESET : 99999:59:59
CYCLE TIME : 99999:59:59
WORKPIECES CUT/AFTER RESET : 9999999999
LOT SIZE : 9999999999
REMAINING WORKPIECES : 999999999
LOT COMPLETION FLAG : 0
(PAL messages)
SET
TIME
SET
DATE
Important: Some softkeys shown in Figure 2.10 might not appear on your
system due to restricted access. Refer to the beginning of this section and
page 2-25 for details.
You can modify the values on this screen. Press the {ED PRT INFO} ,
{SET DATE} , or the {SET TIME} softkeys as explained in the Screen Field
Definitions that follow.
Press the exit softkey {
•
} to save changes and return to the “Active
Program” screen.