Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 267)

Communications
Chapter 9
9-11
5. Select the device to copy from by using this table.
If the peripheral device is connected to: Press this softkey:
Port A {FROM A TO MEM}
Port B {FROM B TO MEM}
The screen is changes to the “COPY PARAMETERS” screen
(Figure 9.3) and displays the current device and setup parameters for
that communication port.
If the device displayed on the screen is not correct, select the correct
device using the procedure described in section 9.1.1
Figure 9.3
Copy Parameter Screen
COPY PARAMETERS
FROM: (SELECTED PORT NAME)
TO: (PROGRAM NAME)
DEVICE: FACIT N4000
BAUD RATE: 2400
PROTOCOL: LEVEL_2*
OUTPUT CODE: ASCII
AUTO FILENAME: NO
STOP PRG END: YES
PROGRAM END: M02, M30
M99
SINGLE
PRGRAM
MULTI
PRGRAM