Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 35)

Basic Control Operation
Chapter 2
2-11
The control can be purchased with a 9-inch monochrome portable operator
panel. This panel can be attached or detached to the 9/Series I/O ring
operator panel interface assembly at any time without disrupting control
operation.
The portable operator panel is attached through a 10 ft portable operator
panel interface cable with a 3--pin D--shell connector at each end. One end
of the cable attaches to the front of the portable operator panel. The other
end attaches to the portable operator panel interface assembly. Refer to
your system installer’s documentation for details on attaching and
detaching the portable operator panel and the locations of the operator
panel interface assembly.
Removable Operator Panel
GND
12V
GND5V
G
ND
5V
GND
5
V
CHA GND
LH
AC
Interface Assembly
Connect Operator Panel
(37 pin D Shell has sockets)
Connect Interface Assembly
(37 pin D Shell has pins)
V
idoe
O
u
t
C
N
4
O
p
er
at
o
r
P
n
l.
C
N
5
Video In CN19M
2.1.5
Portable Operator Panel