Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 716)

Paramacros
Chapter 28
28-16
Table 28.D
System Parameters
Parameter # System Parameter Page
2001 to 2999 Tool Offset Tables 28-18
3000 2 Program Stop With Message (PAL) 28-19
3001 System Timer (PAL) 28-19
3002 System Clock 28-20
3003 2 Block Execution Control 1 28-20
3004 2 Block Execution Control 2 28-21
3006 2 Program Stop With Message 28-21
3007 1 Mirror Image 28-22
4001 to 4120 1 Modal Information 28-22
5001 to 5012 1 Coordinates of End Point 28-23
5021 to 5032 1 Coordinates of Commanded Position 28-24
5041 to 5052 1 Machine Coordinate Position 28-24
5061 to 5069 or
5541 to 5552 1 Skip Signal Position (Work Coordinate) 28-25
5071 to 5079 or
5561 to 5572 1 Skip Signal Position (Machine Coordinates) 28-25
5081 to 5089 or
5581 to 5592 1 Active Tool Length Offsets 28-26
5090 to 5094 1 Probing Cycle Positions 28-27
5095 to 5096 Probe Stylus Length and Radius 28-28
5101 to 5112 1 Current Following Error 28-28
5201 to 5212 External Offset Amount 28-28
5221 to 5232 G54 Work Coordinate Table Value 28-29
5241 to 5252 G55 Work Coordinate Table Value
5261 to 5272 G56 Work Coordinate Table Value
5281 to 5292 G57 Work Coordinate Table Value
5301 to 5312 G58 Work Coordinate Table Value
5321 to 5332 G59 Work Coordinate Table Value
5341 to 5352 G59.1 Work Coordinate Table Value
5361 to 5372 G59.2 Work Coordinate Table Value
5381 to 5392 G59.3 Work Coordinate Table Value
5630 1 S--Curve Time per Block 28-31
5661 to 5642 1 Acceleration Ramps for Linear Acc/Dec Mode 28-31
5651 to 5662 1 Deceleration Ramps for Linear Acc/Dec Mode 28-31