Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 314)

Introduction to Programming
Chapter 10
10-40
Figure 10.6
Cutting Speed
TABLE
WORKPIECE
D
N
Cutting Speed,
speed of tool surface
relative to workpiece
A workpiece usually requires different kinds of cutting processes, and
usually there are cutting tools that correspond to each process. The cutting
tools are typically stored in a tool magazine and are assigned tool numbers
(see Figure 10.7).
Figure 10.7
Tool Magazine
05
06 07 08 09
10
04 03 02 01
10.5.12
T- words (Tool Selection)