Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 804)

Using Transfer Line Cycles
Chapter 31
31-2
The 9/Series T-Line-9 system comes with a set of part program templates
for a wide variety of transfer line applications including:
Drilling/Boring/Tapping Application Infeed Hole Bottom Retract Template Name
Drilling Cycle, No Dwell/Rapid Out Feed Retract Rapid Traverse QV01
Drilling Cycle, Dwell/Rapid Out Feed Dwell /Retract Rapid Traverse QV02
Deep Hole Drill Cycle, Chip Clear Intermittent Feed Retract Rapid Traverse QV03
Deep Hole Drill Cycle, Chip Break Intermittent Feed Retract Rapid Traverse QV04
Right-Hand Tapping Cycle Feed Spindle Reversed / Retract Feed QV05
Right-Hand Solid-Tapping Cycle Feed Spindle Reversed / Retract Feed QV06
Left-Hand Tapping Cycle Feed Spindle Reversed / Retract Feed QV07
Left-Hand Solid-Tapping Cycle Feed Spindle Reversed / Retract Feed QV08
Boring Cycle, No Dwell/Feed Out Feed Retract Feed QV09
Boring Cycle, Spindle Shift Feed Oriented Spindle Stop / Retract Rapid Traverse QV10
Boring Cycle, Spindle Stop/Rapid Out Feed Spindle Stop /Retract Rapid Traverse QV11
Back Boring Cycle Feed Oriented Spindle Stop / retract Rapid Traverse QV12
Boring Cycle, Dwell/Feed Out Feed Dwell/Retract Feed QV13
Transfer Bar and Cross Slide Applications Use Template Name
Single Axis Lift Cycle To lift and set the part off of and on to the transfer bar. Includes a soft touch, soft set. QV14
Single Axis Transfer Cycle To transfer the part between stations. QV15
Two-Axis Transfer Bar Cycle To lift, set and transfer the part between stations. QV16
Single Axis Cross Cycle To make a groove or a cut in a part using a cross slide. QV17
Single Axis Feed Cycle To feed a cutting tool in to or out of a part before or after a cut with a cross-slide is made. QV18
Two-Axis Cross Feed Cycle A combination of the single axis cross cycle and the single axis feed cycle. QV19
31.1
Transfer Line Cycles