Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 689)

Skip, Gauge, and Probing Cycles
Chapter 27
27-15
Figure 27.5
G38.1 Parallel Probing Cycle Paramacro Parameter Values
1st hit
2nd hit
Work piece or fixture
(#5090 Run distance)
(#5091 Rise Distance)
Use this feature to access the Probe Parameters table and alter probe
parameters affecting the operation of the G31, G37, and G38 codes . For
details on the parameters available here, refer to the appropriate section of
this chapter.
Access to this table may be restricted. Refer to chapter 2 regarding access
control.
The parameters available for modification through this table may have
already been defined in AMP. Refer to the documentation provided by
your system installer.
Values entered here will supersede the corresponding AMP value. They
will remain active even if the control is powered down.
To display or alter the values in the probing parameters table follow the
steps below:
1. Press the {SYSTEM SUPORT} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
27.6
Probing Parameters Table