Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 733)

Paramacros
Chapter 28
28-33
#5711 to 5722
Jerk
These parameters are read only. They are only applicable to the current jerk
values when S--Curve Acc/Dec mode is active. You can set these parameters
by programming a G48.5 in your part program block. Control Reset,
Program End (M02/M03), or G48 will reset these values to their default AMP
values. For more information about programming G48.x codes, refer to
chapter 18 in your 9/Series CNC Operation and Programming Manual.
5711 Axis 1 jerk 5717 Axis 7 jerk
5712 Axis 2 jerk 5718 Axis 8 jerk
5713 Axis 3 jerk 5719 Axis 9 jerk
5714 Axis 4 jerk 5720 Axis 10 jerk
5715 Axis 5 jerk 5721 Axis 11 jerk
5716 Axis 6 jerk 5722 Axis 12 jerk
#5731 to 5743
Home Marker Distance
These parameters are read only. They correspond to the current home marker
distance. These parameters will contain the distance to marker calculated
when the axis stopped after the home switch went false during the last
homing operation.
5731 Axis 1 home marker distance 5737 Axis 7 home marker distance
5732 Axis 2 home marker distance 5738 Axis 8 home marker distance
5733 Axis 3 home marker distance 5739 Axis 9 home marker distance
5734 Axis 4 home marker distance 5740 Axis 10 home marker distance
5735 Axis 5 home marker distance 5741 Axis 11 home marker distance
5736 Axis 6 home marker distance 5742 Axis 12 home marker distance