Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 189
Running a Program
Chapter 7
7-7
To select a program for automatic execution:
1.
Press the {PRGRAM MANAGE} softkey. The control displays the
program directory screen as shown in Figure 7.2.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
Figure 7.2
Part Program Directory
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
SELECTED PROGRAM:
DIRECTORY
PAGE
1
OF
1
NAME
SIZE
COMMENT
TEST
AE
3.9
O12345
1.3
SUB TEST 1
MAIN
1.3
SHAFT2
1.3
THIS IS A TEST PROGRAM
XXX
1.3
5 FILES
137.8 METERS FREE
Important: If a program is active, an “A” appears to the right of the
program name. If a program is being edited, an “E” appears to the right of
the program name. Figure 7.2 shows program TEST as active and being
edited. Make sure no part program is currently already active. If a part
program is currently active the control will not allow the selection of a
different part program until the currently active one is deactivated (refer to
section 7.4 on deactivating a part program).