Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set User Manual
Page 691
Skip, Gauge, and Probing Cycles
Chapter 27
27-17
5.
You can change parameter values two ways:
Press the
{REPLCE VALUE}
softkey then type in a new value for the
selected parameter by using the keys on the operator panel. When
you press the
[TRANSMIT]
key, the value typed in will replace the
old value for that parameter.
Press the
{ADD TO VALUE}
softkey then type in a value to add to
the old value for the selected parameter by using the keys on the
operator panel. When you press the
[TRANSMIT]
key, the value
typed in will be added to the old value for that parameter.
REPLCE
VALUE
ADD TO
VALUE
SUB FM
VALUE
UPDATE
& EXIT
QUIT
(softkey level 4)
6.
Exit the probing parameters screen in one of two ways:
If you want to:
Press this softkey:
save your changes and exit
{UPDATE & EXIT}
lose your changes and exit
{QUIT}