Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 253)

Displays and Graphics
Chapter 8
8-37
When power is turned on, the control displays the power turn-on screen.
The following section discusses how to modify information displayed on
this screen at power up.
Editing the System Integrator Message Lines
To edit the system integrator message lines of the power turn-on screen, do
the following:
1. Press the [SYSTEM SUPORT] softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
The control brings you to softkey level 2.
2. Press the [PTOM SI/OEM] softkey.
PRGRAM
PARAM
PTOM
SI/OEM
AMP DEVICE
SETUP
MONI-
TOR
TIME
PARTS
SYSTEM
TIMING
(softkey level 2)
The control changes the screen to display the PTO screen.
* Asterisks indicate the three lines for system integrator messages. The
softkeys used to change these lines are password protected.
3. Use the up or down cursor keys to highlight the line that you want to
change on the PTO screen. The line selected is shown in reverse
video.
8.6
Power Turn-on Screen