Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 218)

Displays and Graphics
Chapter 8
8-2
The screens described above may also show in addition to axis position:
The current unit system being used (millimeters or inches)
E-STOP
The current feedrate
The current spindle speed of the controlling spindle
The current tool and tool offset numbers
The active program name (if any)
The active subprogram name (if any)
The current amount of usable memory remaining
The current operating mode (MDI, manual or automatic)
The current operating status (cycle stop, suspend, start, feedhold)
The current block executing (sequence number)
Up to four blocks of the current program selected for program execution
Subprogram paramacro 01 canned cycle repeat count executing
To select an axis position data display :
1. Press the [DISP SELECT] key, to display the softkeys for selecting
axis position data screens. Press the [DISP SELECT] key at any time
from any softkey level. Pressing the page {
•
} softkey displays
additional selections.
Important: The [DISP SELECT] key is ignored if you are viewing the
PAL search monitor utility. You must select the screen to display before
you access PAL search monitor. Additionally you can not activate PAL
search monitor while viewing the Display Select options.
2. Press the softkey corresponding to the display wanted. The softkeys
will toggle between large and regular display mode each time the
corresponding softkey is pressed, provided that screen is available as
a large display.
The “large” and “small” display is available only for the axis position
screens (Program, Absolute, Target, and Distance to Go). Small
displays are only available when more than 9 axes are AMPed in a
system or, for dual process, more then 8 axes in a process.
For example, immediately after power up and accessing the
[DISP SELECT] feature, pressing the {DTG} softkey displays the
distance to go in normal size. Pressing it again changes the display
to show the distance to go in large character size.
The control can display any 4 axes in triple-height characters and any
6 axes in double-height characters. If you ask the control to display
more than 6 axes on a large display or 9 axis on a normal display, the
control displays the error message, “TOO MANY AXES
SELECTED FOR DISPLAY.” Small displays always show all axes
in the system in the active process.