Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 731)

Paramacros
Chapter 28
28-31
#5630
S- Curve Time per Block
This parameter is read only. The value represents the amount of time
(seconds converted to system scans) for a part program block’s S--Curve filter
where S--Curve Acc/Dec is applied during G47.1 mode. When it is
multiplied by the scan time, the product equals the amount of time required
by the acceleration.
This parameter is only calculated for blocks that have programmed motion
with S--Curve Acc/Dec.
#5631 to 5642
Acceleration Ramps for Linear Acc/Dec Mode
These parameters are read only. They correspond to the active acceleration
ramps in Linear Acc/Dec mode. You can set these parameters by
programming a G48.1 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5631 Axis 1 acceleration ramp 5637 Axis 7 acceleration ramp
5632 Axis 2 acceleration ramp 5638 Axis 8 acceleration ramp
5633 Axis 3 acceleration ramp 5639 Axis 9 acceleration ramp
5634 Axis 4 acceleration ramp 5640 Axis 10 acceleration ramp
5635 Axis 5 acceleration ramp 5641 Axis 11 acceleration ramp
5636 Axis 6 acceleration ramp 5642 Axis 12 acceleration ramp
#5651 to 5662
Deceleration Ramps for Linear Acc/Dec Mode
These parameters are read only. They correspond to the active deceleration
ramps in Linear Acc/Dec mode. You can set these parameters by
programming a G48.2 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5651 Axis 1 deceleration ramp 5657 Axis 7 deceleration ramp
5652 Axis 2 deceleration ramp 5658 Axis 8 deceleration ramp
5653 Axis 3 deceleration ramp 5659 Axis 9 deceleration ramp
5654 Axis 4 deceleration ramp 5660 Axis 10 deceleration ramp
5655 Axis 5 deceleration ramp 5661 Axis 11 deceleration ramp
5656 Axis 6 deceleration ramp 5662 Axis 12 deceleration ramp