Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 93)

Offset Table and Setup
Chapter 3
3-19
Figure 3.6
Backup Offset Screen
TO
PORT A
TO
PORT B
TO
FILE
BACKUP OFFSETS
TOOL WEAR
TOOL GEOMETRY
WORK COORDINATE
ALL
SELECT OPTION USING THE UP/DOWN ARROW
3. Select the offsets to be backed up by moving the cursor to the desired
offset using the up and down cursor keys. The selected offset will be
shown in reverse video. There are four options here:
TOOL WEAR ---- When wear is selected all data from the tool
offset wear tables is stored as a G10 program.
TOOL GEOMETRY ---- When geometry is selected all data from
the tool offset geometry tables is stored as a G10 program.
WORK COORDINATE ---- When work coordinate systems is
selected the work coordinate offset information for the G codes
G54 - G59.3 and the external offset value are stored as a G10
program.
ALL ---- When all is selected all data from the tool offset geometry
and wear tables and work coordinate offset tables is stored as a
G10 program.