Comtech EF Data CDM-625A - Manual (Page 196)

CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 3
6–70
Use the ▲▼ arrow keys to set the L3 QoS operational priority. Press ENTER.
Valid settings are:
Setting Function
Off QoS disabled.
Max/Prio
(Maximum priority only) Provides multi-level traffic prioritization with the ability to limit
maximum traffic per priority class.
MinMax
(Minimum/Maximum priority) Provides a Committed Information Rate (CIR) to each
user-defined class of traffic with the ability to allow a higher burstable rate depending
on availability.
DiffServ
(DiffServ priority only) Industry-standard method of providing QoS, enabling
seamless co-existence in networks that implement DiffServ.
6.2.1.13.3.9 CONFIG: IP  IP Setup: Stats
IPstats: Port x In Out ()
Unicasts: 00000003 00000023 Clr:N
This screen displays IP traffic statistics for both the In (Ingress) and Out (Egress) directions. Use
the ◄ ► arrow keys to navigate to the proper line, in this order:
First, on the top line – Use the ▲▼ arrow keys to select the bottom-line IP Stats Type as WAN,
Ports 1 through 4, HDLC FPGA, or Management. (“In” and “Out” are column labels for the
bottom line parameters and are not selectable.)
Next, on the bottom line – Use the ▲▼ arrow keys to view the desired statistical parameter.
Available statistics are:
IP Stats Type
(Use ▲▼ to select)
Available Statistics
(Use ◄ ► to navigate to the bottom line, and then ▲▼ to display a desired statistic)
• WAN HDLC Frames In / Out
Tx Dropped
Rx CRC Error
• Port 1
• Port 2
• Port 3
• Port 4
• HDLC FPGA
• Management
Unicasts 511 Octets *Indicates In only
**Indicates Out only Broadcasts 1023 Octets
Pause Max Octets
Multicasts Jabber*
FCS Error Oversize*
Align Error* Discards
Good Octets Filtered*
Bad Octets* Collisions**
Undersize Multiple**
Fragments* Single**
64 Octets Deferred**
127 Octets Late**
255 Octets Excessive**