Comtech EF Data CDM-625A - Manual (Page 728)

CDM-625A Advanced Satellite Modem MN-CDM625A
Appendix R Revision 3
R–6
In case VLAN Q-in-Q (double VLAN tag), the L2 VLAN QoS considers first VLAN tag
priority field only for traffic prioritization.
QoS Example 4
1) VLAN-based Layer 2 QoS mode is selected.
2) The modem data rate is set to 1 Mbps.
3) Four streams of VLAN ingress traffic is sent to the modem with VLAN Priorities set to 7, 5, 3,
and 1, respectively.
4) The data rate for each stream is set to 500 Kbps.
QUESTION: What is the total output data rate and what are the individual port output data
rates?
ANSWER:
• Based on Table R-1 for a modem Tx bandwidth of 1 Mbps, the QoS output bandwidth is set
to 1 Mbps.
• Total Input data rate is 4X 500 Kbps = 2 Mbps
• Based on Table R-2, the VLAN Priorities 7, 5, 3, and 1 are mapped, respectively, to L2 QoS
Priorities 4, 3, 2, and 1.
• Since the modem Tx bandwidth and QoS output data rates are the same, there is no need
for normalization.
• The data rate for each port is as follows:
VLAN
Priority
L2 QoS
Priority
Input Data Rate QoS Output Data
Rate
Remaining Data Rate (After
Serving the Priority Queue)
Output Data
Rate
7 4 500 Kbps 500 Kbps 500 Kbps 500 Kbps
5 3 500 Kbps 500 Kbps 0 Kbps 500 Kbps
3 2 500 Kbps 0 Kbps 0 Kbps 0 Kbps
1 1 500 Kbps 0 Kbps 0 Kbps 0 Kbps
Total ► 2 Mbps 1 Mbps 0 Kbps 1 Mbps
QoS Example 5
1) Port- and VLAN-based Layer 2 QoS mode is selected.
2) Port Layer 2 QoS Priorities are set as follows:
• Port 1 priority is set to 1;