Comtech EF Data CDM-625A - Manual (Page 678)

CDM-625A Advanced Satellite Modem MN-CDM625A
Appendix L Revision 3
L–12
Step Task
5 Use needle-nose pliers as needed to plug the fan power
cable receptacle (A) into the mating connector on the
modem’s framing board (B).
IMPORTANT NOTE 1: Note the orientation of the fan’s
power cable receptacle and wiring to the mating connector
and its pins on the modem’s framing board.
IMPORTANT NOTE 2: Take care not to damage the pins
for the mating connector to the PL-0000481 IP Packet
Processor Card.
6 Prepare the IP Packet Processor Card for installation by
aligning its receptacle with the mating connector on the
modem’s framing board.
Plug the card firmly into the connector – take care not to
damage any top-mounted components. Similarly, be sure
not to damage the bottom of the card on the chassis’
mounting bosses while plugging the card receptacle into its
mating connector.
Installation is complete once the cable connector is fully
engaged within its mating receptacle, and the mounting
holes at the front of the card are aligned with the mounting
boss threaded holes.