Comtech EF Data CDM-625A - Manual (Page 237)

CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 3
7–7
7.4.2 Using the Telnet Interface for Telnet Command Line Interface (CLI)
Operation
(LEFT) TeraTerm CLI Example
(RIGHT) PuTTY CLI Example
Figure 7-1. CDM-625A Telnet Command Line Interface (CLI)
1) The CDM-625A Telnet Command Line Interface (CLI) is accessible only when you
install and enable the optional IP Packet Processor.
2) The CDM-625A Telnet CLI uses Telnet TCP Port 107 . Be sure to specify this port
when configuring your terminal emulator for CLI operation.
3) The HyperTerminal terminal emulator, while compatible for use with remote
control operations, is not
Figure 7-1
supported or recommended for CDM-625A Telnet CLI
operation. Instead, for best results Comtech EF Data recommends PuTTY or
Tera Term or as the preferred terminal emulators ( ).