Comtech EF Data CDM-625A - Manual (Page 199)

CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 3
6–73
6.2.1.13.5 CONFIG: IP AccessList
Use this menu to restore SNMP/HTTP access if your own IP Address is inadvertently
excluded from the Host Access List while configuring the list through either the
SNMP or Web Server (HTTP) interface.
The Host Access List allows you to define which remote clients can connect when the Access List
is enabled. Each entry allows a user to specify an IP address and a subnet mask to define a
unique class of machines that are allowed access.
Once you define and enable an access list via SNMP or the CDM-625A Web Server interface
‘Admin | Access’ page, functionality of this menu appears as follows:
Host Access List is Enabled
Disable the List: No (N,Y) ()
Use the ▲▼ arrow keys to select N (No) to maintain the active Host Access List, or Y to disable
the list. Press ENTER.
Once you disable the list, this message appears whenever you select the CONFIG: IPAccessList
menu:
Host Access List is Disabled
Use HTTP or SNMP to configure the list.
6.2.1.13.6 CONFIG: IP  PktP-Enable
You may access this menu only when you have installed the optional IP Packet
Processor card.
Packet Processor: Enabled (Ena, Dis) ()
(Modem will auto-reboot after change!)
Use the ▲▼ arrow keys to select the card as Ena(bled) or Dis(abled):
• The default mode is Ena(bled).
• When you disable the IP Packet Processor, the card and its accompanying functionality is
completely bypassed and the modem reverts to its base modem Layer 2 switch
functionality.
Press ENTER. The modem will automatically reboot after this configuration change.