Comtech EF Data CDM-625A - Manual (Page 247)

CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 3
7–17
7.5.4.2.2 Admin | SNMP
• Chapter 6. FRONT PANEL OPERATION
• Sect. 7.3 SNMP INTERFACE
The Administrator must use this page to set and return administration information for the
CDM-625A SNMP (Simple Network Management Protocol) feature.
Figure 7-5. Admin | SNMP page
SNMP
• Simple Network Management – Use the drop-down list to select as Disabled or Enabled.
• Enable Authentication Trap – Use the drop-down list to select as Disable or Enable.
• Assign up to two SNMP Trap IP Addresses in the form xxx.xxx.xxx.xxx.
• Trap Version – Use the drop-down list to select SNMPv1 or SNMPv2.
• SNMP Read/Write/Trap Community Strings, SNMP Contact/Name/Location – Create or
edit these alphanumeric text strings as follows:
Setting Factory Default Typical Parameters
SNMP Read Community String public The Read, Write, and Trap Community Strings
can be any alphanumeric combination with a
maximum length of 4 to 15 characters.
SNMP Write Community String private
SNMP Trap Community String comtech
SNMP Contact N/A
The SNMP Contact, Name, and Location strings
can be any alphanumeric combination with a
maximum length of 0 to 20 characters.
SNMP Name N/A
SNMP Location N/A
• SNMP Access Level – Use the drop-down list to select Read and Write (default) or Read
Only.
Click [Submit Admin] to save.