Comtech EF Data CDM-625A - Manual (Page 503)

CDM-625A Advanced Satellite Modem MN-CDM625A
CDM-625A ODU (Transceiver, BUC, LNB) Operation Revision 3
10–35
10.4 ODU Operations via the CDM-625A HTTP (Web Server) Interface
The CDM-625A Advanced Satellite Modem’s embedded HTTP Interface provides an
easy to use application to configure and monitor all aspects of an ODU. See Chapter
7. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT for complete instructions
on using this interface.
The Comtech EF Data LPOD Amplifier / Block Up Converter is not supported by the
CDM-625A HTTP Interface at this time.
A user-supplied web browser allows the full monitor and control (M&C) of an installed Comtech
EF Data CSAT-5060 or KST-2000A/B Transceiver (ODU), installed in standalone or 1:1
Redundancy configurations, from the CDM-625A’s Web Server Interface. This embedded web
application is designed for, and works best with, Microsoft’s Internet Explorer Version 7.0 or
higher.
10.4.1 Web Server Interface and Menu Tree
Type the CDM-625A’s IP Address into the Address area of the user-supplied web browser, and
then enter a valid User Name and Password is accepted. You will see the CDM-625A Web Server
Interface “splash” page (Figure 10-3). Note that the Base Modem and Packet Processor
Firmware Versions shown in this example are subject to change.
Figure 10-3. CDM-625A HTTP (Web Server) Interface Home Page
The Figure 10-4 menu tree illustrates the ODU options available through the CDM-625A HTTP
Interface. The CDM-625A Web Server Interface provides access to six (6) navigation tabs (shown
in blue). Beyond this top-level row of navigation tabs, the diagram illustrates the available primary
(green) and nested (yellow) page tabs that afford you more specific functionality.