Comtech EF Data CDM-625A - Manual (Page 259)

CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 3
7–29
• VLAN Table – This read-only table provides the user with the status for VLAN entry on a per-
ID (0001-4095) and per-Port (1-4) basis, where U=Untagged, T=Tagged, and F=Filtered.
7.5.4.3.2.2 Configuration | LAN | ARP
This nested page is accessible only to Admin users and when you install and enable
7.5.3.1 the optional IP Packet Processor card. See Sect. for complete details about
using conditional access pages.
ARP (Address Resolution Protocol) is a technique by which the HTTP Interface in Router Mode
on a given network answers the ARP queries for a network address that is not on this network,
but is reachable via the IP Packet Processor Interface.
Use this page to configure the modem’s ARP parameters.
Figure 7-14. Configuration | LAN | ARP page
ARP Table (Edit)
This section displays all current Static and Dynamic ARP entries, and allows to user to directly
edit the current Static ARP entries, when more than one ARP entry exists. Note the following:
Column Description
Index This is the internal table index that is automatically assigned and cannot be edited.
IP IP Address, in the format XXX.XXX.XXX.XXX.
MAC MAC Address, in the format YY:YY:YY:YY:YY:YY.
Type Type is identifiable as Static or Dynamic (cannot be edited).
Click [Submit Changes] to save.