Comtech EF Data CDM-625A - Manual (Page 491)

CDM-625A Advanced Satellite Modem MN-CDM625A
CDM-625A ODU (Transceiver, BUC, LNB) Operation Revision 3
10–23
10.3.3.3.3.3.1.3 ODU: FSK-control  KST  Configuration 
Miscellaneous
HPA:Off Fault-Logic=Summary
LNA:OFF Fault-Logic=Summary Cal:No
Use the ◄ ► arrow keys to select HPA, (HPA) Fault-Logic-Summary, LNA, (LNA) Fault-Logic-
Summary, or Cal, and then use the ▲▼ arrow keys to change that setting:
Selection Setting
HPA (HPA power enable) Select Off or On.
Fault-Logic
This controls whether or not a HPA fault is indicated on the Fault status, and activates the
Summary Fault Relay. Select Summary or No-Summary.
LNA (LNA power enable) Select Off or On.
Fault-Logic
This controls whether or not a LNA fault is indicated on the Fault status, and l activates
the Summary Fault Relay. Select Summary or No-Summary.
Cal
To calibrate, select YES and press ENTER. Calibration allows the system to determine
nominal LNB or LNB power consumption, performed at initial installation only. (Default is
NO.)
Press ENTER when done.
10.3.3.3.3.3.1.4 ODU: FSK-control  KST  Information
KST Info: Model Tx+Rx-Param
Misc Numbers ()
These read-only screens provide the ODU’s current configuration information without risking
inadvertent changes.
Use the ◄ ► arrow keys to select Model, Tx+Rx-Param, Misc, or Numbers, and then press
ENTER.
Once any KST Info screen has been viewed, press ENTER or CLEAR to return to the previous
menu.
10.3.3.3.3.3.1.5 ODU: FSK-control  KST  Information  Model
MODEL: KST-2000B
HPA: CEFD-SSPA
This screen displays the KST and HPA model numbers.