R.3.3 layer 3 qos diffserv mode, R.3.3.1 layer 3 qos congestion avoidance – Comtech EF Data CDM-625A User Manual

Page 734

Advertising
background image

CDM-625A Advanced Satellite Modem

MN-CDM625A

Appendix R

Revision 3

R–12

R.3.3

Layer 3 QoS DiffServ Mode

Layer 3 DiffServ QoS is fully compliance to RFC standards. When the Layer 3 QoS mode is set to

DiffServ, the system automatically configures the rules with DSCP code points, priority values,

and WRED. You can only configure the service rate and drop precedence levels for Assured

Forwarding (ASFD) classes.

R.3.3.1 Layer 3 QoS Congestion Avoidance

The Layer 3 QoS system supports Weighted Random Early Detection (WRED) based congestion

avoidance. WRED can be enable or disabled on any queue. When WRED is disabled, upon

overdriving the queue the packets will be tail dropped.

QoS Example 8

1)

DiffServ Layer 3 QoS mode is selected.

2)

The modem Tx bandwidth is set to 10 Mbps.

3)

The data rate of the modem drops down from 10 Mbps to 8.7 Mbps due to EbNo.

4)

The input data streams to the modem are the same as those of QoS Example 7.

QUESTION: What is the total output data rate and what are the individual port output data

rates?

ANSWER:

The Layer 3 QoS system first drains Priority 1 traffic. Since the management data stream is

only 200 Kbps, after serving Priority 1 traffic, QoS still has 9.8 Mbps (10.0-0.2=9.8).

QoS next drains Priority 2’s 800 Kbps traffic. After the end of the Priority 2 traffic, QoS still

has 9 Mbps traffic available (9.8-0.8=9).

Similarly, QoS walks through all priorities until it hits the ASFD classes:

o

The beginning of ASFD Classes QoS leftover bandwidth is 2 Mbps.

o

All ASFD classes have the same Priority of 7, with different service rates.

o

ASFD service rate is a Committed Information Rate (CIR), except serviced if bandwidth

available after serving all high priority queues. In this case, 2 Mbps bandwidth is

available, serving all service rates first. The total of all ASFD service rates are 1.6 Mbps,

which is less than the 2 Mbps leftover bandwidth.

o

After serving the service rates, the leftover bandwidth is 400 Kbps. This 400 Kbps will be

distributed to all ASFD classes equally in round robin fashion until either there is no

more bandwidth, or the input streams have no data.

Advertising