Comtech EF Data CDM-625A - Manual (Page 249)

CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 3
7–19
Next Reboot, will use
Use the drop-down list to select Image 1 or Image 2 as the image to use upon next reboot, and
then click [Submit] to save this selection.
7.5.4.2.3.2 Admin | Firmware | Packet Processor
This nested page is accessible only to Admin users and when you install and enable
7.5.3.1 the optional IP Packet Processor card. See Sect. for complete details about
using conditional access pages.
Use this page to view the status window for the optional IP Packet Processor’s currently loaded
firmware, and to set the firmware load preference for the IP Packet Processor upon power-
up/reboot of the unit.
Figure 7-7. Admin | Firmware | Packet Processor page
Firmware
• (Read-only) The IP Packet Processor’s Bootrom, Image 1, Image 2, and current Running
image are identified here.
• Boot From – Use the drop-down list to boot the IP Packet Processor from Latest, Image 1, or
Image 2, and then click [Submit] to save this selection.