Comtech EF Data CDM-625A - Manual (Page 197)

CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 3
6–71
You may clear the IP Statistics accumulators by using the ◄ ► arrow keys to move the cursor to
Clr:N; then, use the ▲▼ arrow keys to select Clr:Y. Press ENTER.
6.2.1.13.3.10 CONFIG: IP  IP Setup: FrmSize
2048 Ethernet Frame Size:
Enabled (Dis/Ena) ()
Use the ▲▼ arrow keys to set 2048-byte Ethernet packet sizes as Enabled or Disabled. Press
ENTER.
6.2.1.13.4 CONFIG: IP  ANT (Advanced Network Timing)
IP Protocols: SNTP PTP
()
Use the ▲▼ arrow keys to select SNTP or PTP. Press ENTER.
6.2.1.13.4.1 CONFIG: IP  ANT  SNTP (Simple Network Time Protocol)
SNTP: Disabled (Disabled, Enabled)
Servers: Primary Backup ()
You may use Simple Network Time Protocol (SNTP) to synchronize computer clocks throughout
a computer network when the ultimate performance of the full NTP implementation (as per
RFC-1305 (Requests for Comment No. 1305: Network Time Protocol, Version 3, Specification,
Implementation and Analysis)) is not needed or justified.
On the top line – Use the ▲▼ arrow keys to select SNTP as Enabled or Disabled.
• When Enabled, SNTP contacts the time server to update the Real-Time Clock (RTC) every 24
hours.
• When Disabled, no such notifications take place.
On the bottom line – Use the ◄ ► arrow keys to first navigate to the bottom line, and then
select the Primary or Backup Server submenu.
Press ENTER to continue.
Where [######] Time Server denotes “Primary Time Server” or “Backup Time Server”:
[#######] Time Server: 192.168.001.010
Last Update: Never ()