Yaskawa YASNAC PC NC Maintenance Manual User Manual
Page 148
Advertising
The VS-626M5
PC NC Maintenance Manual
4-127
•
Use twisted shielded wires for motor encoder signal lines and
connect both ends as shown in the figure below.
Figure 4.18: Shielded Wire Termination (Shielded at Both Ends)
Wiring Inspection
After completing the installation and wiring, check for the following items.
Never use the control circuit buzzer check.
•
Wiring is correct
•
Wire clippings or screws are not left in the unit
•
Screws are securely tightened
•
Bare wire in the terminal does not contact other terminals.
Shielded Sheath
Armor
To inverter shielded
sheath terminal
Insulate these parts
with insulating tape.
To encoder shielded
sheath terminal
Advertising