Yaskawa YASNAC PC NC Maintenance Manual User Manual
Page 156
The VS-626M5
PC NC Maintenance Manual
4-135
The figures below show the display section and operation keys of
the digital operator, and the LED display status of the RUN and
STOP keys. Table 4.31 shows the displayed characters and the
corresponding alphabets and numbers, and Figure 4.24 shows the
display of bit selection signal.
Figure 4.22: Display Unit and Operation Keys of the Digital Operator
LOCAL
REMOTE
DIGITAL OPERATOR
JVOP-132
DSPL
DATA
ENTER
JOG
FWD
REV
RESET
RUN
STOP
DRIVE FWD
REV
REMOTE
REF
SEQ
DRIVE
PRGM
Mode Display LED
Display
Display Selection Key
JOG
DRIVE FWD REV
REMOTE
REF
SEQ
Digital Operator Running Indicatio
Lights in the digital operator operation mode
Rotation Direction Indication
FWD: Lights when forward run command is
@ @ input.
REV: Lights when reverse run command is
@ @ input.
Remote Mode Indication
SEQ: Lights when the motor rotates in the
@ @ reverse direction.
REF: * * *
Displays monitored values of speed reference
and function set values.
Depress this key to select display item
Read/Write Key
Depress this key to display set values of
constants. Depress this key again to write
set values.
Numeral Change Key
Use these keys to change values such as set
values and constant Nos.
È: Increment key
É: Decrement key
Digit Selection Key
Use this key to select a position in a set value
to be changed. The selected position blinks.
(Use this key to reset after and error occurs.)
Run Command Key
These are run command keys when the drive is oper
ated by the digital operator. These keys are effective
only in operation by digital operator.
STOP: Stop command
@ @When STOP is depressed, the red LED on
@ @the left part of the key lights.
RUN: Run command
@ @When RUN is depressed, the red LED on
@ @the left part of the key lights.
FWD/REV: Forward and reverse rotation switch
@ @When this key is depressed, direction of
@ @ @rotation is changed.
JOG: Jog run
@ @When this key is held down, jog run is available.
DRIVE/PRGM: Emergency stop
@ @When this key is depressed, the operation speed
@
@
@is reduced and stopped. Then current is interrupted.