Yaskawa YASNAC PC NC Maintenance Manual User Manual
Page 67
PC NC Maintenance Manual
Chapter 4: Troubleshooting
4-46
AL-b0
Initial starting point tak-
ing-in (=incorporation)
error
C-phase signal cannot be detected when initial
starting point taking-in after power supply is ON.
(IPM motor).
1011 A
AL-b1
Encoder pulse number
error
Encoder pulses per one rotation exceeded ±10
pulses of a normal value (IPM motor).
1011
A
AL-b2
Low-speed winding
acceleration error
Motor speed exceeded the low-speed winding
maximum speed by a low-speed winding. (IPM
motor).
1011
A
AL-d1
A/D converter for the
speed command defec-
tive
A/D converter for the speed command of the I/O
card is defective.
1101 A
AL-d2 CPU
integrated
A/D
converter defect
CPU integrated A/D converter is defective.
1101
A
AL-d3
U phase A/D converter
defect
A/D converter for the U phase current detection is
defective.
1101 A
AL-d4
W phase A/D converter
defect
A/D converter for the W phase current detection is
defective.
1101 A
AL-d5
Control circuit I/O error
1
Data transmission error between CPUs [C196 side
detection]
1101 A
AL-d6
Control circuit I/O is
error 2
Data transmission error between CPUs [DSP side
detection]
1101 A
AL-d7
Control circuit I/O error
3
Data transmission error between CPUs [C196 side
detection at initialization].
1101 S
AL-E0
Motor code selection
error
Selected motor code (C1-25) and inverter capacity
(C1-56) don’t match.
1110 S
AL-E1
Motor code unregis-
tered
Motor code setting in the C1-25 is not registered. 1110
S
AL-E2 Parameter
set
range
defect
Memory (EEPROM) data exceeded the upper and
lower limit value.
1110 S
AL-E3
Orientation card mis-
match
Orientation selection bit and the orientation card do
not agree.
1110 A
AL-E4
Inverter capacity selec-
tion error
Selected inverter capacity (C1-56) and unit don’t
match.
1110 S
AL-F0
ROM defect
Memory (PROM) is defective. [Sum check error]
1111
A
AL-F1 EEPROM
(EEPROM)
defect 1
Memory (EEPROM) is defective. [Verification error] 1111
S
AL-F2 EEPROM
(EEPROM)
defect 2
Memory (EEPROM) is defective. [EEPRM initial-
ization code error]
1111 S
AL-F3 EEPROM
(EEPROM)
defect 3
Memory (EEPROM) is defective. [BCC check
error]
1111 S
AL-F4 EEPROM
(EEPROM)
defect 4
Memory (EEPROM) is defective. [defective write-in
at on-line mode].
1111 A
CPF00
Control circuit error 1
5 seconds has past after power was turned ON,
inverter control card and operator transmission are
not consistent.
----
S
Table 4.18: Alarm Descriptions (Continued)