3 setting up the sigma-series servopack, 1 parameters, 3 setting up the σ -series servopack – Yaskawa Sigma Mini User Manual
Page 82
APPLICATIONS
2.3.1 Parameters
— 2-38 —
2.3
Setting Up the Σ-Series Servopack
This section describes how to set parameters to operate the Servopack.
2.3.1 Parameters
Σ-Series Servopacks provide many functions, and have parameters called “parameters” to
allow the user to specify each function and perform fine adjustment.
The Digital Operator is used to set parameters.
Parameters are divided into the following two types.
Memory switch
Cn-01, Cn-02
Each bit of this switch is turned ON or OFF to specify a
function.
Parameter setting
Cn-03 and later
A numerical value such as a torque limit value or speed
loop gain is set in this constant.
• For Speed/Torque Control:
Parameter
Name and Code
Remarks
Cn-01
Memory switch
Each bit number has a
Cn-02
Memory switch
Each bit number has a
switch (ON/OFF).
Cn-03
VREFGN
Speed reference gain
Cn-..
...
...
Parameter setting
Cn-..
...
...
Parameter setting
Cn-2C
OUTS2
Output signal selection 2
• For Position Control:
Parameter
Name and Code
Remarks
Cn-01
Memory switch
Each bit number has a
Cn-02
Memory switch
Each bit number has a
switch (ON/OFF).
Cn-04
LOOPHZ
Speed loop gain
Cn-..
...
...
Parameter setting
Cn-..
...
...
Parameter setting
Cn-2C
OUTS2
Output signal selection 2
For a list of parameters, refer to Appendix C List of Parameters.
2