Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors - Manual (Page 205)

5.9 Compatible Adjustment Function
5-61
5
Adjustments
(1) Related Parameters
Select the conditions to switch modes (P or PI control switching) by using the following parameters.
„ Parameters to set the detection point
Mode switch functions according to the detection point are as follows.
„ Using the Force Reference Level to Switch Modes (Factory Setting)
With this setting, the speed loop is switched to P control when the value of force reference input exceeds the
force set in Pn10C.
The factory setting for the force reference detection point is 200% of the rated force.
Parameter
Mode Switch
Selection
Parameter
Containing
Detection Point
Setting
When
Enabled
Classification
Pn10B
n.†††0 Uses a force reference level for detection point.
[Factory setting]
Pn10C
Immediately Setup
n.†††1 Uses a speed reference level for detection point. Pn181
n.†††2 Uses an acceleration level for detection point. Pn182
n.†††3 Uses an position error pulse level for detection
point.
Pn10F
n.†††4 Does not use mode switch function. −
Pn10C
Mode Switch (Force Reference)
Classification
Setting Range Setting Unit Factory Setting When Enabled
0 to 800 1% 200 Immediately Tuning
Pn181
Mode Switch (Speed Reference)
Classification
Setting Range Setting Unit Factory Setting When Enabled
0 to 10000 1 mm/s 0 Immediately Tuning
Pn182
Mode Switch (Acceleration)
Classification
Setting Range Setting Unit Factory Setting When Enabled
0 to 30000 1 mm/s 2 0 Immediately Tuning
Pn10F
Mode Switch (Position Error Pulse)
Classification
Setting Range Setting Unit Factory Setting When Enabled
0 to 10000 1 reference unit 0 Immediately Tuning
Speed Position
Speed Position
Speed Position
Position
Motor speed
Speed reference
Speed
+Pn10C
Force
reference
- Pn10C
Force reference
PI Control PI Control
0
PI P P
Time