Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors - Manual (Page 34)

1 Outline
1.6.1 Connecting to SGDV-†††FE5A SERVOPACK
1-14
1.6 Examples of Servo System Configurations
This section describes examples of basic servo system configuration.
1.6.1 Connecting to SGDV-
††† FE5A SERVOPACK
∗ Before connecting an external regenerative resistor to the SERVOPACK, refer to 3.7 Regenerative Resistors Connec-
tions.
Noise filter
Molded-case
circuit breaker
(MCCB)
Magnetic
contactor
I/O signal cable
SGDV- FE5A
SERVOPACK
Command Option
Module
Power supply
Single-phase 100 VAC
R T
Protects the power
supply line by shutting
the circuit OFF when
overcurrent is detected.
Used to eliminate
external noise from
the power line
Turns the servo ON
and OFF.
Install a surge
absorber.
Personal
computer
Cable for connecting
personal computer
Digital
operator
When not using the safety function,
use the SERVOPACK with the
safety function’s jumper connector
(JZSP-CVH05-E provided as an
an accessory) inserted.
When using the safety function,
insert a connection cable
specially for the safety function.
External device such as
external LED indicator
Safety function
devices
Cable for connecating
digital operator
Main circuit cable
for linear servomotor
Serial converter unit
Cable for connecting
serial converter unit
Linear servomotor
with core
Linear scale
(not included)
Cable for connecting
hall sensor
Cable for connecting
linear scale
Regenerative
resistor *