Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors - Manual (Page 307)

9 Appendix
9.1.2 Parameters
9-22
Pn587
Polarity Detection for Absolute Scale
Selection
0000 to 0001 − 0000 Immediately Setup −
Pn600 Regenerative Resistor Capacity
∗2
Depends on
SERVOPACK
Capacity
∗3
10 W 0 Immediately Setup 3.7.2
Pn601 Reserved (Do not change.) – – 0 – – –
Pn800 to
Pn95F
4
Reserved (Do not change.) – – 0 – – –
∗2. Normally set to “0.” When using an external regenerative resistor, set the capacity (W) of the regenerative resistor.
∗3. The upper limit is the maximum output capacity (W) of the SERVOPACK.
∗4. For details on Pn800 to Pn95F, refer to the manual of the connected Command Option Module.
Parameter
No.
Name
Setting
Range
Units
Factory
Setting When Enabled Classification
Refer-
ence
Section
4th
digit
3rd
digit
2nd
digit
1st
digit
n.
Polarity Detection for Absolute Scale Selection
0
1
Reserved (Do not change.)
Does not detect polarity.
Detects polarity.
Reserved (Do not change.)
Reserved (Do not change.)