Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors - Manual (Page 301)

9 Appendix
9.1.2 Parameters
9-16
Pn50B
Input Signal Selection 2 0000 to FFFF − 8882 After restart Setup −
Pn50C Reserved (Do not change.) – – 8888 – – –
Pn50D Reserved (Do not change.) – – 8888 – – –
Parameter
No.
Name
Setting
Range
Units
Factory
Setting
When
Enabled
Classification Reference
Section
4th
digit 3rd
digit 2nd
digit 1st
digit
n.
/P-CL Signal Mapping
N-OT Signal Mapping
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Valid when CN1-13 input signal is ON (L-level).
Valid when CN1-7 input signal is ON (L-level).
Valid when CN1-8 input signal is ON (L-level).
Valid when CN1-9 input signal is ON (L-level) .
Valid when CN1-10 input signal is ON (L-level).
Valid when CN1-11 input signal is ON (L-level).
Valid when CN1-12 input signal is ON (L-level).
Reverse run prohibited.
Reverse run allowed.
Valid when CN1-13 input signal is OFF (H-level).
Valid when CN1-7 input signal is OFF (H-level).
Valid when CN1-8 input signal is OFF (H-level).
Valid when CN1-9 input signal is OFF (H-level).
Valid when CN1-10 input signal is OFF (H-level).
Valid when CN1-11 input signal is OFF (H-level).
Valid when CN1-12 input signal is OFF (H-level).
0 to F
/N-CL Signal Mapping
Reserved (Do not change.)
0 to F Same as N-OT signal mapping
Same as N-OT signal mapping
(Refer to 4.2.3)