Yaskawa Sigma-5 User Manual: Design and Maintenance - Linear Motors - Manual (Page 292)

9.1 List of Parameters
9-7
9
Appendix
Pn00C
Application Function Select Switch C 0000 to 0111 − 0000 After restart Setup −
Pn00D
Application Function Select Switch D 0000 to 0001 – 0000 After restart Setup −
Pn010 Axis Address Selection 0000 to 007F – 0001 After restart Setup –
Pn080
Application Function Select Switch
80
0000 to 1111 – 0000 After restart Setup –
Parameter
No.
Name
Setting
Range
Units
Factory
Setting
When
Enabled
Classification Reference
Section
Reserved (Do not change.)
Reserved (Do not change.)
4th
digit 3rd
digit 2nd
digit 1st
digit
n.
0
1
Selection of Test without Motor
Disables Test without motor.
Enables Test without motor.
0
0
Encoder Type for Test without Motor
Incremental linear scale
Absolute linear scale
(Refer to 4.3.3)
(Refer to 4.3.3)
Reserved (Do not change.)
n.
Reserved (Do not change.)
0
1
Stand-alone Mode (Test Operation) Selection
Enables connection with the command option module.
Disables connection with the command option module.
Reserved (Do not change.)
4th
digit 3rd
digit 2nd
digit 1st
digit
0
1
Motor Phase Selection
Calculation Method for Maximum Speed or Divided Output Pulses
4th
digit 3rd
digit 2nd
digit 1st
digit
n.
Sets phase A lead as phase sequence of U, V, W.
Sets phase B lead as phase sequence of U, V, W.
Reserved (Do not change.)
0
1
Determines divided output pulses with fixed maximum speed.
Determines maximum speed with fixed divided output pulses.
0
1
Hall Sensor Selection
Enables selection.
Disables selection.