Kyocera TASKalfa 2552ci - Manual (Page 135)

2-68
Installing and Setting up the Machine > Command Center RX
5 Click [Submit].
POP3 POP3 Protocol You don't need to set the following items when you only
enable the function of sending e-mail from the machine. Set
the following items if you want to enable the function of
receiving e-mail on the machine.
Command Center RX User Guide
Check Interval
Run once now
Domain Restriction
POP3 User Settings
E-mail
Send
Settings E-mail Size Limit Enter the maximum size of E-mail that can be sent in
kilobytes. When E-mail size is greater than this value, an
error message appears and E-mail sending is cancelled.
Use this setting if you have set E-mail Size Limit for SMTP
server. If not, enter a value of 0 (zero) to enable E-mail
sending regardless of the size limit.
Sender Address
*1
Specify the sender address for when the machine sends E-
mails, such as the machine administrator, so that a reply or
non-delivery report will go to a person rather than to the
machine. The sender address must be entered correctly for
SMTP authentication. The maximum length of the sender
address is 128 characters.
Signature Enter the signature. The signature is free form text that will
appear at the end of the E-mail body. It is often used for
further identification of the machine. The maximum length
of the signature is 512 characters.
Function Defaults Change the function default settings in [Common/Job
Default Settings] page.
*1 Be sure to enter the items.
Setting Description