Kyocera TASKalfa 2552ci - Manual (Page 308)

6-28
Using Various Functions > Functions
Mixed Size Stapling
Even with mixed paper sizes, if the sizes have the same width as shown in the combinations below, the output can be
stapled.
• A3 and A4
• B4 and B5
• Ledger and Letter
• Ledger and Letter-R
• 8K and 16K
Punch
Punches holes in sets of finished documents.
NOTE
• Number of sheets that can be stapled: up to 30 sheets.
• When performing Mixed Size Stapling, refer to the following:
Mixed Size Originals (page 6-20)
NOTE
• This function requires the optional Document Finisher and Punch Unit.
• For details on paper sizes that can be punched, refer to the following:
Punch Unit (For Inner Finisher) (page 11-28)
Punch Unit (For 1,000-Sheet/4,000-Sheet Finisher) (page 11-30)
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item Value Description
Punch Off
2 holes Left Select the position of punch holes. For details on original
orientation and position of punch holes, refer to the
following:
Original Orientation and Punch Hole Position (page
6-29)
2 holes Top
2 holes Right
3 holes Left
3 holes Top
3 holes Right
4 holes Left
4 holes Top
4 holes Right
Original
Orientation Top Edge on Top, Top Edge on Left,
Auto
*1
*1 This function can only be used when the optional OCR Scan Activation Kit is installed.
Select the orientation of the original document top edge
to scan correct direction. Select [Original Orientation]
to choose orientation of the originals, either [Top Edge
on Top] or [Top Edge on Left]. Then select [OK].
A3 A4
B4 B5
Ledger Letter
B5
Ledger Letter
A3 A4
B4
Legal Letter-R
Legal Letter-R