Kyocera TASKalfa 2552ci User Manual
Page 553
10-42
Troubleshooting > Troubleshooting
S
Message
Checkpoints
Corrective Actions
Reference
Page
Scanner memory is
full.
*1
*1 When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time
elapses. For details on Auto Error Clear, refer to the following:
—
Scanning cannot be performed
due to insufficient memory of the
scanner. Follow the instructions
on the screen.
—
Scheduled sending
jobs exceeded.
—
The number of jobs has
exceeded the limit set for
delayed transmission. Select
[End]. The job is canceled.
Wait until the delayed
transmission is executed, or
cancel the delayed transmission
and then perform the job again.
—
Send Error.
—
An error has occurred during
transmission. The job is
canceled. Select [End]. Refer to
Responding to Send Error for
the error code and corrective
actions.
Has the staple cartridge holder
run out of staples?
If the staples are depleted, the
machine will stop and the
location of staple depletion will
be indicated on the screen.
Leave the machine on and
follow the instructions to replace
the staple case. Select
[Continue] to print without
stapling. Select [Cancel] to
cancel the job.
Staple is empty.
(Manual Staple)
Has staple cartridge holder A
run out of staples?
Add staples to staple cartridge
holder A.
Staple jam.
—
If a staple jam occurs, the
machine will stop and the
location of the jam will be
indicated on the screen. Leave
the machine on and follow the
instructions to remove the
jammed staple.
System error.
—
System error has occurred.
Follow the instructions on the
screen.
—