Drum refresh, Calibration, Drum refresh -55 calibration -55 – Kyocera TASKalfa 2552ci User Manual

Page 566

Advertising
background image

10-55

Troubleshooting > Adjustment/Maintenance

2

As shown in the illustration, place the printed side down on the platen with the edge with
the arrows toward the back.

3

Select [Start]. The pattern is read and adjustment begins.

The second pattern is output.

4

Check that the number "2" is printed at the bottom of the pattern and repeat steps 2 to 3 to
read pattern 2.

5

Select [OK] in the adjustment end confirmation screen.

Drum Refresh

Remove image blur and white dots from the printout.

1

Display the screen.

[System Menu/Counter] key > [Adjustment/Maintenance] > "Drum Refresh" [Next]

2

Perform the drum refresh.

Select [Start]. "Drum Refresh" begins.

Calibration

Calibrate the device to ensure correct toner overlapping and consistency with the original tone.

1

Display the screen.

[System Menu/Counter] key > [Adjustment/Maintenance] > "Calibration" [Next]

NOTE

Drum Refresh cannot be performed while printing. Execute Drum Refresh after the printing is done.

Advertising