Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 237)

Unified IP MIB Reference 209
53-1002549-02
Interface ID2 to ifIndex lookup table
Interface ID2 to ifIndex lookup table
The Interface ID2 to ifIndex lookup table is useful for mapping a known interface to the
corresponding ifIndex value. If the provides an interface ID2, this table returns the ifIndex value.
NOTE
The contents of the interface ID2 to ifIndex lookup table can only be accessed using GET operations.
Unlike other SNMP tables, this table does not support GET-NEXT operations. If you try to walk the
table using GET-NEXT, no rows will be returned.
snIfIndexLookupInterfaceId
brcdIp.1.1.3.3.4.1.2
Syntax: InterfaceId Read-only Shows the interface ID, which consists of the following:
Octet 0 – Port type, which can be one of the following:
•
1 – Ethernet
•
2 – POS
•
3 – ATM
•
4 – Virtual
•
5 – Loopback
•
6 – GRE Tunnel
•
7 – ATM Subif
•
8 – MPLS Tunnel
•
9 – ATM PVC
•
10 – Management
•
11 – Trunk
•
12 – IP Tunnel (for IP tunnels, except MPLS)
This value also applies to 6 - 4 tunnels in the Brocade NetIron
devices,
Octet 1
•
If the value of Octet 0 is 1, 2, 3, 7, or 9, then this octet shows
the slot number of the device.
•
If the value of Octet 0 is 6 or 8, then this octet shows the
tunnel ID.
•
If the value of Octet 0 is 5, then this octet shows the loopback
ID.
•
If the value of Octet 0 is 4, then this octet shows a virtual ID.
Octet 2 – If the value of Octet 0 is 1, 2, 3, 7, or 9, then this octet
shows the port number.
Octet 3 – If the value of Octet 0 is 7 or 9, then this octet shows the
ATM Subif number).
Octet 4 – If the value of Octet 0 is 9, then this octet shows the ATM
VPI number.
Octet 5 – If the value of Octet 0 is 9, then this octet shows the ATM
VCI number.
Name, OID, and syntax Access Description