Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 723)

Unified IP MIB Reference 695
53-1002549-02
Proprietary traps
Trap name and number Varbinds Severity Description and trap message
snTrapOspfIfStateChange
1.3.6.1.2.1.14.16.2.3 snOspfRouterId (The
originator of the trap)
snOspfIfStatusIpAddres
s
snOspfIfStatusState
(The new state) Informational There has been a change in the state of a
non-virtual OSPF interface. This trap
should be generated when the interface
state regresses (for example, goes from Dr
to Down) or progresses to a terminal state
(for example, Point-to-Point, DR Other, Dr,
or Backup).
NOTE: You must configure the log
adjacency command under the
"router ospf" mode to see traps.
Sample trap message:
OSPF router id
<snOspfRouterId>, interface
<snOspfIfStatusIpAddress>
state changed to
<snOspfIfStatusState>.
snTrapOspfVirtIfStateChan
ge
1.3.6.1.2.1.14.16.2.4 snOspfRouterId (The
originator of the trap)
snOspfVirtIfStatusAreaI
D
snOspfVirtIfStatusNeig
hbor
snOspfVirtIfStatusState
(The new state) Informational There has been a change in the state of an
OSPF virtual interface. This trap should be
generated when the interface state
regresses (for example, goes from
Point-to-Point to Down) or progresses to a
terminal state (for example, Point-to-Point).
NOTE: You must configure the log
adjacency command under the
"router ospf" mode to see traps.
Sample trap message:
OSPF router id
<snOspfRouterId>, virtual
interface area id
<snOspfVirtIfStatusAreaID>
neighbor
<snOspfVirtIfStatusNeighbor>
state changed to
<snOspfVirtIfStatusState>.