Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 303)

Unified IP MIB Reference 275
53-1002549-02
NP statistics table
brcdNPStatsRxRouteOnlyDrop
brcdIp.1.14.2.1.1.21
Syntax: Counter 64 Read-only Shows the number of packets dropped due to the
route-only configuration during MAC-DA processing.
brcdNPStatsRxIPv6SuppressRPFDrop
brcdIp.1.14.2.1.1.22
Syntax: Counter 64 Read-only Shows the number of suppressed IPv6 RFP drops on
the ingress path due to ACL override.
brcdNPStatsRxIPv6RPFDropCount
brcdIp.1.14.2.1.1.23
Syntax: Counter 64 Read-only Shows the number of IPv6 RPF drops on the ingress
path.
brcdNPStatsRxIPv4Bytes
brcdIp.1.14.2.1.1.24
Syntax: Counter 64 Read-only Shows the number of raw packet bytes (+FCS) that have
IPv4 EType (0x0800) and IP version (0x4).
brcdNPStatsRxIPv6Bytes
brcdIp.1.14.2.1.1.25
Syntax: Counter 64 Read-only Shows the number of raw packet bytes (+FCS) that have
IPv6 EType (0x86DD) and IP version (0x6).
brcdNPStatsRxPOSCtrlProtocolPkts
brcdIp.1.14.2.1.1.26
Syntax: Counter 64 Read-only Shows the number of control protocol packets received
in the POS mode.
NOTE: This object is supported only on the POS
interfaces. For other interfaces, this object
returns “0”.
brcdNPStatsRxPOSLinkDrop
brcdIp.1.14.2.1.1.27
Syntax: Counter 64 Read-only Shows the number of packets dropped due to the link
state in the POS mode.
NOTE: This object is supported only on the POS
interfaces. For other interfaces, this object
returns “0”.
brcdNPStatsRxRoutedPktsDrop
brcdIp.1.14.2.1.1.28
Syntax: Counter 64 Read-only Shows the number of IPv4 or IPv6 routed packets that
are received and then dropped because the time-to-live
(TTL) is “0” or routing is not enabled on the given virtual
interface.
brcdNPStatsTxSentToMACPkts
brcdIp.1.14.2.1.1.29
Syntax: Counter 64 Read-only Shows the total number of packets sent to a MAC
address for transmission.
brcdNPStatsTxRawGoodPkts
brcdIp.1.14.2.1.1.30
Syntax: Counter 64 Read-only Shows the total number of packets sent to egress
processing logic that pass the initial length checks.
brcdNPStatsTxSrcPortSupressDrop
brcdIp.1.14.2.1.1.31
Syntax: Counter 64 Read-only Shows the number of packets dropped because of the
suppression of the transmit source port.
brcdNPStatsTxBadPktCnt
brcdIp.1.14.2.1.1.32
Syntax: Counter 64 Read-only Shows the total number of packets dropped in egress
logic that fail the initial length checks.
brcdNPStatsTxUnicastPkts
brcdIp.1.14.2.1.1.33
Syntax: Counter 64 Read-only Shows the number of unicast packets transmitted.
brcdNPStatsTxBroadcastPkts
brcdIp.1.14.2.1.1.34
Syntax: Counter 64 Read-only Shows the number of broadcast packets transmitted.
Name, OID, and syntax Access Description