Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 335)

Unified IP MIB Reference 307
53-1002549-02
VLAN by AppleTalk cable configuration table
VLAN by AppleTalk cable configuration table
The following table applies to protocol VLANs that use the AppleTalk routing protocol.
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron MLX, Brocade
NetIron XMR, Brocade NetIron CES, and Brocade NetIron CER series devices.
snVLanByIpxNetVLanName
brcdIp.1.1.3.2.4.1.13
Syntax: DisplayString Read-write Shows the name of the community string that can access this
VLAN.
Valid values: Up to 32 characters
snVLanByIpxNetStaticPortList
brcdIp.1.1.3.2.4.1.14
Syntax: OCTET STRING Read-write Lists the membership of a VLAN by IPX network. Each port index is
a 16-bit integer in big-endian order. The first 8 bits are the slot
number; the other 8 bits are the port number.
snVLanByIpxNetExcludePortLi
st
brcdIp.1.1.3.2.4.1.15
Syntax: OCTET STRING Read-write Lists the ports that are excluded from the VLAN by IPX network
membership. Each port index is a 16-bit integer in big-endian order.
The first 8 bits are the slot number; the other 8 bits are the port
number.
snVLanByIpxNetDynamicPortLi
st
brcdIp.1.1.3.2.4.1.16
Syntax: OCTET STRING Read-only Lists the ports that can dynamically join the membership of the
VLAN by IPX network. Each port index is a 16-bit integer in
big-endian order. The first 8 bits are the slot number; the other 8
bits are the port number.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snVLanByATCableTable
brcdIp.1.1.3.2.5 None A table of VLAN by AppleTalk network number.
snVLanByATCableVLanId
brcdIp.1.1.3.2.5.1.1
Syntax: Integer Read-only The VLAN ID of a port VLAN to which the AppleTalk cable VLAN
attaches.
Valid values: 1 – 4095
snVLanByATCableIndex
brcdIp.1.1.3.2.5.1.2
Syntax: Integer Read-only The AppleTalk cable VLAN index number.
snVLanByATCableRouterIntf
brcdIp.1.1.3.2.5.1.3
Syntax: Integer Read-write Shows the virtual interface of a router to the AppleTalk Cable
VLAN.
Valid values: 0 – 60; however, an SNMP-Get will equal zero if this
object is not configured. Only router products accept the
SNMP-SET operation.