Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 630)

602 Unified IP MIB Reference
53-1002549-02
VPLS endpoint2 table
VPLS endpoint2 table
The following table supports VPLS ISID mapping that is configured in the inner VLAN at the
endpoint level. It contains objects for the VPLS endpoints that are not available in the pseudo Wire
or draft-ietf-pwe3-pw-mib-11.txt MIB. The VPLS endpoint table replaces fdryVplsEndPointTable.
fdryVllEndPointVlanTagMode
brcdIp.1.2.15.2.1.1.1.2
Syntax: Integer32 Read-only Indicates the VLAN mode of this endpoint. Ports can have only
the following modes:
•
tagged(1)
•
untagged(2)
fdryVllEndPointClassOfService
brcdIp.1.2.15.2.1.1.1.3
Syntax: Unsigned32 Read-only For VLL, this value is used to select the appropriate tunnel whose
CoS value is the same as, or almost approaching this value.
For VLL-local, this value is applied to the inbound traffic of an
endpoint.
Valid values: 0 - 7
fdryVllEndPointInHCPkts
brcdIp.1.2.15.2.1.1.1.4
Syntax: Counter64 Read-only This object indicates the number of packets ingressing into this
endpoint. This is available in the output for show mpls statistics
vll.
fdryVllEndPointOutHCPkts
brcdIp.1.2.15.2.1.1.1.5
Syntax: Counter64 Read-only This object indicates the number of ingress packets from this
endpoint as shown in the show mpls statistics vll-local output.
For VLL-local, this value is the fdryVllEndPointInHCPkts of the
other endpoint.
fdryVllEndPointAdminStatus
brcdIp.1.2.15.2.1.1.1.6
Syntax: Integer32 Read-only The desired administrative status of the endpoint.
•
up(1)
•
down(2)
fdryVllEndPointOperStatus
brcdIp.1.2.15.2.1.1.1.7
Syntax: PwOperStatusTC Read-only Indicates the operational status of the endpoint:
•
up(1)
•
down(2)
fdryVllEndPointRowStatus
brcdIp.1.2.15.2.1.1.1.8
Syntax: RowStatus Read-only Status will be active(1) if the endpoint is up; otherwise it will be
not in service.
fdryVllEndPointInnerVlanId
brcdIp.1.2.15.2.1.1.1.9
Syntax: PwVlanCfg Read-only This value indicates the inner VLAN ID for this endpoint.
Default: 0 (not configured or not supported.)
fdryVllEndPointInHCOctets
brcdIp.1.2.15.2.1.1.1.10
Syntax: Counter64 Read-only This value indicates the number of octets into the endpoint from
a Customer Edge device.
This object is supported only on the Brocade NetIron CES and
Brocade NetIron CER series devices.
fdryVllEndPointOutHCOctets
brcdIp.1.2.15.2.1.1.1.11
Syntax: Counter64 Read-only This value indicates the number of octets egressing out from the
endpoint towards the Customer Edge device.
Name, OID, and syntax Access Description